Dynamic Power Detailed Presentation
The AMP-F2, developed in collaboration between the Starke Sound team and the Eversolo team, is based on the innovative NS600 module created by the Starke Sound team. It boasts a high sampling rate of up to 600KHz. Simultaneously, it significantly reduces noise and enhances dynamic performance through the newly designed SAPS audio-specific switch power supply. It employs an efficient Class D amplification structure, cou- pled with optimized circuits to maximize audio quality. The AMP-F2 is bridgeable, allowing flexible configuration for 2-channel or mono-channel setups when needed.
Vigorous Output Bridged Support
The AMP-F2 is equipped with Starke Sound’s NS600 amplifier module, each channel can output a con- stant 250W RMS (42) @ 1% THD+N. When bridged, it can support up to 450W RMS (2) with THD+N still below 1%. This ability to handle extremely low-impedance loads ensures ample energy even in large and challenging speaker setups, particularly during high-dynamic low-frequency outputs.
Output Power
145W RMS at 8 ohms (1% THD)
250W RMS at 4 ohms (1% THD)
280W RMS at 4 ohms (1% THD, BTL)
450W RMS at 2 ohms (1% THD, BTL)
• Gain 21.5dB
• Channel quantity 2
• Amplifier type Class D
o Frequency Response: 10Hz-20KHz – 1dB • Maximum output current per channel
16.5A/33A(Bridge)
• Signal-To-Noise Ratio (SNR)
>110dB, “A” weighted at 4 ohm 250W
• THD: 0.003% 10W at 1KHz
• Input terminals: 2-Channel RCA Input 2-Channel XLR Input
• Input Impedance (RCA): 11KQ
o Input Impedance (XLR) 22K0
o Input Sensitivity: 2.7V
o Output terminals 2 pairs beryllium copper binding post
custom made by Starke Sound
• Output Impedance: 0.1362(5 Hz to 100 kHz)
• Minimum load impedance 0.80
• True balance circuit: Yes
• Heat
65 BTU / hr
• Power consumption
Standby ≤0.5W Idle ≤14W
Maximum 900W
• Control option
12V trigger input & output
o Cabinet Aluminum (Black)
• Size: 270x228x80 (mm)
Special order item.